SCLakes.com

need to see if you have power @ the switch. Is there a fuse blown? How much votage do you have? What type year, make, motor do you have? What type and name boat? These thing will help

_________________
Go get the wheel barrow Son

its a 1997 johnson 150 fassstrike boat is 1998 triton tr 18 voltage is fine, seems to have power to switch when i turn it on the switch all the gauges come on, Where are the fuses located that go to the switch checked all fuses on the main panel all were good. Thanks for the help michael

You have a inline fuse under the cowl near battery cable coming from the battey. Should be red and says fuse on it. you may have to take a cover off to see it held on by two phillips head screws. on the port side of engine near starter.

_________________
Go get the wheel barrow Son

If not the fuses ? any other suggestions? thanks again for your help michael

Neutral safety switch maybe not be closed. hold switch in start postion, move gear shifter back & forth to see if you can find a spot were the starter may try to turn.

_________________
Go get the wheel barrow Son

well its none of the above problems best I can tell. Any other suggestions to check before i take it to a mechanic. Thanks Michael

when you turn the key to the "on" position , does the system check light up & beep?

_________________
One tequila, two tequila, three tequila, floor.....

They come on and beep what does that mean

It means that your ignition has applied power to the alarm circuit and has sent the signal back to the horn or gauge. This does not mean the motor will start. It only means it is ready to start. You MUST have spark when the motor is cranked to apply spark to a 60* motor like yours you must have good voltage on the cranking battery, Once the motor spins the stator will apply the voltage to fire the motor and the optical sensor will pick off the trigger when to fire. You can pull the starboard side amp connector from the power pack to verify fire but be ready to pull all plug wires as you can't cut it off from the key switch. I would recommend you have H20 running on cooling muffs to the motor before attempting this procedure.

_________________
I'm not fluent in Idiot could you please speak slowly?

and if fires or starts that way what is wrong with the fix? thanks michael

Sounds like you need to take to a service tech like Championman or Michael Martain

_________________
Go get the wheel barrow Son

Power Pack.

_________________
I'm not fluent in Idiot could you please speak slowly?

power pack? how much for power pack and to get it installed price?

last question so it would let me jump it off from the switch and start it if the power pack was bad? thanks for everyones help again? Thanks michael