SCLakes.com

Has anyone had any experience with the relay switch that comes off of the starting battery. This is the switch that allows you to turn your accessories and finders on. I have a 2005 and when the switch is pushed down I'm still not getting any power to the accessories. Do these switches go bad? Anything else I need to look for before I try and replace the switch?

If I'm not mistaken Ranger changed the style of the breaker to a blade type breaker. Do you have the touch pad dash board? If so do you have lights on the dash?

_________________
I'm not fluent in Idiot could you please speak slowly?

Blue Sea Systems Series 185 Thermal Circuit Breaker - Surface Mount

4.0(1 review)

Read 1 ReviewWrite a Review









Blue Sea Systems Series 185 Thermal Circuit Breaker - Surface Mount
Ignition protected - Safe for installation aboard gasoline powered boats
Meets SAE J1171 external ignition protection requirements
Weather Resistant
Combines switching and circuit breaker function into one unit
"Trip Free" - cannot be held closed after trip
Series 185 Circuit Breaker Specifications
Operating Temperature Range -25C to +82C
Terminal Stud Torque 70 in-lb
Interrupt Rating 3,000 Amperes
Maximum Voltage Rating 42 Volts DC
Weight Lb (Kg) Weight Lb (Kg)
Circuit Breaker Type Thermally responsive bi-metal blade
Case Material Phenolic
Circuit Breaker Class Type III - Switchable/Manual Reset - Trip Free

BRAND: Blue Sea Systems
Current: 42V DC
Type: Circuit Breakers

_________________
Go get the wheel barrow Son

OK......The circuit breaker issue has been resolved. The switch has something loose in it and it causes it to short out. Tap it a few times and it works. So that has to be replaced. The next issue that just came up is that the Speedo is not working. Everything else works but the speedo. Does anyone know if there is a fuse box and if there is where is it? I've looked everywhere.

speedo is based on water pressure. prob a cloged hose on the gearcase.

what motor do you have?

_________________
One tequila, two tequila, three tequila, floor.....

Merc 250 EFI. There's a water pressure gauge on the dash. Would this measurement be taken from the same place the speed is measured?

Merc 250 EFI. There's a water pressure gauge on the dash. Would this measurement be taken from the same place the speed is measured?

Merc 250 EFI. There is a water pressure gauge on the dash. Is the speed taken from the same place that the water pressure gauge gets its reading? Do you know of a fuse box?

Water pressure is taken off the motor usually somewhere close to the adapter plate that gives you the out put of the water pump. The speedo is either taken from a separate pick up (pitot) either on the hull or from the lower unit on the motor. Look just above the bullet of the nose cone on the lower and you should see a small hole. they sometimes get debris in them. to fix that take a small drill and by HAND twist it in there to clear the hole. Fuse box should be under the console.

_________________
I'm not fluent in Idiot could you please speak slowly?

I used my DeWalt XRP 18 volt cordless drill and cleaned out the pin head sized hole above the cone. It was full of debris and appears to be working fine now. Thanks for all the help. I really did it by hand.