The schematic is for the right reel, only mine is a size 30. I added an additional "#9" washer and re-spooled it and it worked like a champ. The line is evenly distributed obver the spool.
Thanks for you help jiminportbass and theone. You guys rock!
Statistics: Posted by archer8030 — Mon May 12, 2008 8:19 pm
]]>
The schematic above is very helpful. You can either remove or add the #9 washer(s) in order to balance the distribution of the line. Sometimes they come from the factory a bit out of tune. Adding a washer will actually lift the spool a bit in order to distribute the line closer to the "back" of the spool....and vise versa.
Hope this helps
Statistics: Posted by theone — Mon May 12, 2008 6:03 pm
]]>
Since you have some other reels of the same kind check to see if this one has all the spacers on the shaft that would put the spool at the proper highth.
Also look to see if the barrel assembly is sitting on the reel properly.
Just a few things to look at while your playing telephone tag with service department.
Let me know if I can help ya.
This may not be your reel but should be about the same.
Statistics: Posted by jiminportbass — Sun May 11, 2008 4:38 pm
]]>
]]>
]]>
]]>
]]>
]]>
]]>